After some relatively intensive training over the last week and a half I have finally found my way back to the workbench.
I'm back to the HO scale group from ScaleHumans on Shapeways. I only had time to do the basic wash to bring out the details on these. This really made the detail pop, but it also emphasized the printing lines on them as well. You can definitely see the difference between the Tan Fine Detail plastic and the Clear Ultra Fine Detail plastic. When I order again I'm definitely going with the Clear Ultra Fine.
Like with previous work this initial thin wash is done with Reaper Miniatures' Brown Liner. Because I do two thin washes I use Vallejo Airbrush thinner to thin it out instead of water.
 |
| These seated engineers are all printed in Ultra |
.
 |
| Pretty sure this one is in tan |
 |
| These three are all done in tan plastic |
 |
| This is a mix. The two on the left are in tan the two on the right are in ultra |
No comments:
Post a Comment